24/7 Parking Surveillance

1. Directly to the battery for constant 24hrs/7days power to protect against theft when your car is in the parking lot.
2. Directly to the ignition wire for power only so it can turn on and off with the ignition.

Compatible 12 – 24V Vehicles

This hardwire kit accepts voltage from any type of vehicle runs on 12 – 24V, and works perfectly for cars, trucks, buses, SUVs, or big rigs for continuous power.

Low Voltage Protection

Smart low voltage protection automatically shut off the power to your dash cam when the battery voltage drops to 11.6V(12V cars) or 23.2V(24V cars), thus preventing it from draining the battery.

Find the Correct Fuse Slot

Open the fuse box, and find the correct fuse slot for your hardwire kit. If you need to find an ignition-switched fuse, put the key in the vehicle, find the fuse which is not lit up while the car is off, and test it by turning the car on to see if it lights up. If your kit requires constant power, turn off the car and remove the key to see which fuse slots stay lit.

Connect the Red Wire and Yellow Wire

Once you’ve determined which fuse slots you need to use for your hardwiring kit you can crimp the red wire of your hardwire kit onto the Add-A-Fuse. Gently remove the fuse you identified. Install the fuse you just removed into the installation kit and add-a-fuse circuit. Plug the add-a-circuit into the fuse box in the correct orientation. And the Yellow should be connected to the ACC.

Ground the Hardwiring Kit

Slip the black wire (which is in the shape of a C) under a metal bolt or screw in your vehicle (this is the ground wire). Check that it is not attached to plastic parts. You will typically need a socket wrench to loosen the nut or bolt that you choose to ground with. To attach the grounding terminal, loosen the nut or bolt enough to slip it in and tighten it back up afterward.